Pelco DD53TC16-X Manuel d'utilisateur télécharger pdf (Page 33)

C2446M-E (11/05) 33

ACK ACTION

Acknowledge action programs the alert label behavior after the alert condition has been

acknowledged. The following settings are available for ACK ACTION:

ALWAYS ON The alert label is displayed until alert conditions are cleared.

OFF 8 HRS The alert label is turned off for 8 hours. Label returns after 8 hours

if the alert condition persists.

OFF 24 HRS The alert label is turned off for 24 hours. Label returns after 24

hours if the alert condition persists.

OFF 48 HRS The alert label is turned off for 48 hours. Label returns after 48

hours if the alert condition persists.

ACTIVATE AUX

This setting activates an auxiliary when an alert condition exists. ACTIVATE AUX settings include

the following:

NO (default) Not activated.

1 An alert condition will close AUX 1.

2 An alert condition will close AUX 2.

CURRENT READING

The Current Reading menu displays the existing status of temperature, pressure, and dew point

inside the dome system. An arrow displayed to the left of a menu item denotes that an alert

condition exists.

An up arrow indicates the reading is over the threshold. A down arrow indicates the reading is

below the threshold.

The high temperature alert occurs if the temperature is above 140°F (60°C).

The low temperature alert occurs if the temperature is below -40°F (-40°C).

The high pressure alert occurs if the pressure is above 11 PSIG.

The low pressure alert occurs if the pressure is below 1 PSIG.

The dew point (high humidity) alert occurs if the difference between the temperature and the

dew point is less than or equal to 3°C.

NOTE: The normal operating temperature inside the unit will be greater than the temperature

outside the back box due to the heat emitted by the system’s electronics.

RESET ALERT

Reset alert clears the alert condition and removes the alert label from the monitor. The system

automatically checks internal conditions 60 seconds after reset. If conditions are still unaccept-

able, the alert label reappears on the screen indicating further corrective action is required.

BACK

EXIT

REPEAT CONSTANT

ACK ACTION ALWAYS ON

ACTIVATE AUX NO

RESET ALERT

ALERT

BACK

EXIT

TEMPERATURE 0°C

0°F

DEWPOINT 0°C

0°F

PRESSURE 0.0 PSIG

0.0 BAR

REFRESH 2

CURRENT READING

EXIT

SPECTRA III

LANGUAGE ENGLISH

ACK ALERT

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

<ZONES>

<ALERT>

<CLEAR>

BACK

EXIT

DOME SETTINGS

(See page 11)

Quick Programming Guide

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Pelco DD53TC16-X Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Caméras de sécurité Pelco DD53TC16-X