Pelco DVR DX3016-060 Manuel d'utilisateur télécharger pdf (Page 31)

30 Pelco Manual C681M-D (2/02)

CALL OUT

A signal from the CALL OUT terminal can be sent to an external device to warn when the

hard disk drive or archive device reaches the remaining capacity set in this menu. The call

out signal can also activate another recorder if the CALL OUT terminal is wired to the

record (REC) input of another recorder.

Skip steps 1 and 2 if they have already been done.

1. Press the SET UP button to display the Menu Setting menu.

2. Turn the JOG dial to move the cursor to REAR TERMINAL, and then turn the

SHUTTLE ring to the right. The Rear Terminal menu appears.

3. Turn the JOG dial until the cursor is next to CALL OUT, and then and turn the

SHUTTLE ring to the right. The Call Out menu appears.

4. Check that the cursor is next to HDD, and then turn the SHUTTLE ring to the right.

The option starts flashing.

5. Turn the JOG dial to select the option, and then turn the SHUTTLE ring to the right.

The option stops flashing.

Turning the JOG dial switches the call out options as follows:

NONE, FULL, 2%, 4%, 6%, 8%, 10%, 15%, 20%, 30%, 40%, 50%

NONE: No signal is sent from the CALL OUT terminal.

6. If an archive device is connected to the recorder, turn the JOG dial until the cursor is

next to ARCHIVE, and then turn the SHUTTLE ring to the right. The option starts

flashing.

7. Turn the JOG dial to select the option, and then turn the SHUTTLE ring to the right.

The option stops flashing.

8. Turn the SHUTTLE ring to the left once to return to the Rear Terminal menu or twice to

return to the Menu Setting menu, or press the SET UP button to exit the programming

mode.

CAPACITY REMAINING

When the remaining storage capacity of the main hard drive (HDD) or archive device

reaches the preset amount set in this menu, the recorder does the following:

•A signal is sent from the Mode Out terminal when the MODE OUT field in the Rear

Terminal menu is set to REMAIN.

• The recorded storage capacity flashes when Display Mode 3 is selected.

• The buzzer sounds when the buzzer field in the Rear Terminal menu is set to REMAIN.

Skip steps 1 and 2 if they have already been done.

1. Press the SET UP button to display the Menu Setting menu.

2. Turn the JOG dial to move the cursor to REAR TERMINAL, and then turn the

SHUTTLE ring to the right. The Rear Terminal menu appears.

3. Turn the JOG dial until the cursor is next to CAPACITY REMAIN, and then turn the

SHUTTLE ring to the right. The device option starts flashing.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 84 85

Pas de commentaire

Pelco DVR DX3016-060 Manuel d'utilisateur Page 31