Pelco WCS1-4 Manuel d'utilisateur télécharger pdf (Page 6)

6 C561M-E (8/05)

OUTPUT WIRING

To install the output wiring to the camera, dome, or positioning system, refer to Figure 4 and do the

following:

1. Refer to Table A and determine the output connection needed for your camera, dome, or

positioning system. Refer to Figure 4, for the proper connector strip connections.

2. Attach one output wire to either the Tap A (24 VAC), Tap B (26 VAC), or Tap C (28 VAC)

connections on the Secondary Output Tap’s connector strip and attach the second wire to the

COM connection on the same strip. Be sure that you have the proper wiring size and distances

installed if you plan to change connections later.

3. Close the lid to the WCS1-4 power supply, replace the retaining screw to the door latch, and

then turn power on.

Figure 4. Wiring Connector Diagram

120V - F 1.6A H

240V - F 0.5A H

FUSE HOLDER

INPUT TERMINALS

SPARE FUSES

OUTPUT TERMINALS

GROUND STUD

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Pelco WCS1-4 Manuel d'utilisateur Page 6