Pelco WCS1-4 Manuel d'utilisateur télécharger pdf (Page 4)

4 C561M-E (8/05)

INSTALLATION

MOUNTING INSTRUCTIONS

To mount the power supply directly to a wallboard, wall, or concrete refer to Figures 1 through 3

and do the following:

1. Remove the retaining screw from the door latch of the WCS1-4 power supply.

2. Open the door of the WCS1-4 power supply, and then remove the plug(s) from the required

conduit hole(s) located on the bottom of the unit. Install 3/4-inch (1.91 cm) conduit fitting(s) (not

supplied). Close the lid to the power supply.

3. Determine the mounting location for the WCS1-4.

4. Use the WCS1-4 power supply as a template and mark the four fastener positions on the

mounting surface.

5. Prepare the holes for installation.

6. Attach the WCS1-4 power supply securely to the mounting surface with four fasteners of

appropriate length. Fasteners between 1/4-inch and 5/16-inch diameter (not supplied) can be

used.

MOUNTING HARDWARE WITH

ANCHOR OR TOGGLE BOLT

(NOT SUPPLIED)

WALLBOARD

RETAINING

SCREW

DOOR

LATCH

WOOD SCREW

(NOT SUPPLIED)

WALL

RETAINING

SCREW

DOOR

LATCH

CONCRETE

WALL

MOUNTING

HARDWARE

(NOT SUPPLIED)

RETAINING

SCREW

DOOR

LATCH

Figure 3.

Mounting to Concrete

Figure 2.

Mounting to

Wall

Figure 1.

Mounting to

Wallboard

WARNING: Under light load conditions and high input power voltage, output voltage

from the WCS1-4 power supply may reach 32 VAC. Pelco recommends that all

equipment connected to the WCS1-4 power supply be rated to handle 32 VAC.

Pelco’s Spectra

domes and Esprit

integrated positioning systems meet this require-

ment.

Pelco cannot be liable for any damages resulting from incorrect wiring of the WCS1-4

power supply.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Pelco WCS1-4 Manuel d'utilisateur Page 4

Commentaires sur ces manuels