Pelco DX9100 Manuel d'utilisateur télécharger pdf (Page 71)

C636M-E (4/05) 71

DATA TRANSLATOR CONFIGURATION

Integrating a data translator serves two functions:

• Synchronize time between the DX9100 system and the matrix switcher.

• Send ASCII command strings to the matrix switcher (CM6800/CM9740/CM9760) for alarm conditions, such as sending

alarms based on motion detection.

NOTE: This programming is required only on the recorder that is physically connected to the CM9760-DT.

Follow these steps to configure a data translator unit.

1. Go to Start > Programs > DX9000 Server > IO Handler Configuration. The following dialog box appears.

NOTE: You can also open the I/O Handler from the DX9000 Server Configuration Utility.

Figure 86. Data Translator I/O Handler Configuration Dialog Box

2. Click Select Driver on Device 2 to define the external device driver that is connected to the server. The following dialog

box appears.

Figure 87. CM9760 Data Translator Driver Dialog Box

3. Select CM9760DT.dll.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 85 86

Pas de commentaire

Pelco DX9100 Manuel d'utilisateur Page 71