Pelco DX8000 Manuel d'utilisateur

DX8000-256RAMInstallation ManualC1602M (6/04)Digital Video RecorderDX8000

8 C1602M (6/04)Install the DX8000-256RAM Memory Module1. Carefully remove the DX8000-256RAM DIMM module from its static-safe packaging. Handle the DIM

C1602M (6/04) 93. Align the DIMM module with the socket so that the notch in the module lines up properly with the break in theDIMM socket. Refer to F

10 C1602M (6/04)5. Carefully, but firmly, push the DIMM module into the empty socket until it is properly seated. The module is properlyseated when th

C1602M (6/04) 11Reassemble the Unit1. Replace the chassis cover using the same screws you removed from the side and rear of the unit. Refer to Figure

12 C1602M (6/04)2. Attach the silver part label that came in your upgrade kit to the inside of your DVR’s front door.a. Remove the paper backing from

C1602M (6/04) 133. Reinstall the unit in a rack enclosure if necessary, and reconnect all cables and peripheral equipment that youremoved earlier.4. P

14 C1602M (6/04)Verify Installation of New RAM1. After the DX8000 application starts, log in as an administrator level user and exit to the Windows® o

C1602M (6/04) 1544. Verify that the amount of RAM is now 512 MB. Refer to Figure 15.Figure 15. System Properties Dialog Box5. Click OK to exit the Sys

16 C1602M (6/04)Notes

PRODUCT WARRANTY AND RETURN INFORMATIONPRODUCT WARRANTY AND RETURN INFORMATIONWARRANTYPelco will repair or replace, without charge, any merchandise pr

Protecting people and property in a million locations worldwide.

C1602M (6/04)® Pelco and the Pelco logo are registered trademarks of Pelco. © Copyright 2004, Pelco. All rights reserved.Worldwide Headquarters3500 Pe

C1602M (6/04) 1IntroductionThe following instructions serve as a guide for the installation of the DX8000-256RAM memory expansion module.PARTS LISTQty

2 C1602M (6/04)Getting Ready1. Familiarize yourself with the instructions throughout this manual.2. Check that you have all the necessary parts and to

C1602M (6/04) 3Figure 3. Removing Power Cord from Unit

4 C1602M (6/04)Figure 4. ESD Protection5. Ensure that the DX8000 Series DVR and all of its components are protected against electrostatic discharge (E

C1602M (6/04) 5Prepare Unit for RAM InstallationOPEN THE UNIT CHASSISWARNING: The chassis assembly includes parts with sharp edges. To avoid injury, u

6 C1602M (6/04)3. Using a Phillips-head screwdriver, remove the chassis cover:WARNING: Make sure unit is turned off and you are wearing a properly gro

C1602M (6/04) 7COMPONENT LAYOUTFigure 6 shows the location of your DX8000 Series DVR’s major components. Certain cables and components have beenomitte