Pelco pelco c561m-h Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
4 C561M-H (3/08)
Description
The WCS1-4 is a single power supply designed for indoor or outdoor applications and is ideal for use with
cameras, domes, and integrated positioning systems such as Spectra
®
and Esprit
®
.
The WCS1-4 power supply has one fused output and is capable of handling up to 4 amps (100 VA) of total
load. The unit features selectable 100/120/240 VAC input power, selectable 24/26/28 VAC output power,
and a stainless steel link-lock latch that can be secured with padlock (padlock not provided).
Installation
MOUNTING INSTRUCTIONS
To mount the power supply directly to a wallboard, wall, or concrete refer to Figure 1 through 3 and do the
following:
1. Remove the retaining screw from the door latch of the WCS1-4 power supply.
2. Open the door of the WCS1-4 power supply, and then remove the plug(s) from the required conduit
hole(s) located on the bottom of the unit. Install 3/4-inch (1.91 cm) conduit fitting(s) (not supplied).
Close the lid to the power supply.
3. Determine the mounting location for the WCS1-4.
4. Use the WCS1-4 power supply as a template and mark the four fastener positions on the mounting
surface.
5. Prepare the holes for installation.
6. Attach the WCS1-4 power supply securely to the mounting surface with four fasteners of
appropriate length. Fasteners between 1/4-inch and 5/16-inch diameter (not supplied) can be used.
Figure 1.
Mounting to Wallboard
Figure 2.
Mounting to Wall
Figure 3.
Mounting to Concrete
WARNING: Under light load conditions and high input power voltage, output voltage from the
WCS1-4 power supply may reach 32 VAC. Pelco recommends that all equipment connected to the
WCS1-4 power supply be rated to handle 32 VAC. Pelco’s Spectra domes and Esprit integrated
positioning systems meet this requirement. Pelco cannot be liable for any damages resulting from
incorrect wiring of the WCS1-4 power supply.
CONDUIT
FITTINGS
CONDUIT
FITTINGS
CONDUIT
FITTINGS
Mounting to Wallboard
Mounting to Wall
MOUNTING HARDWARE WITH
ANCHOR OR TOGGLE BOLT
(NOT SUPPLIED)
Mounting to Concrete
WOOD SCREW
(NOT SUPPLIED)
MOUNTING
HARDWARE
(NOT SUPPLIED)
CONCRETE WALL
WALL
WALLBOARD
DOOR
LATCH
RETAINING
SCREW
DOOR
LATCH
RETAINING
SCREW
DOOR
LATCH
RETAINING
SCREW
Vue de la page 3
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire