Pelco DVR5300 Manuel d'utilisateur télécharger pdf (Page 14)

14 C1629M-F (3/08)

Equipment Placement and Rack Mounting

UNPACKING THE DVR5300

The DVR5300 Series digital video recorder ships with two smaller boxes as shown in Figure 7. One contains the hard drive pack. The other

contains the accessory pack.

Figure 7. Unpacking the DVR5300 Series

To unpack the DVR5300:

1. Remove the boxes marked HARD DRIVE PACK and ACCESSORY PACK.

2. Use a cloth or pad to protect the workbench or other flat surface.

3. With the help of another person, lift the DVR5300 out of its box and onto the protected surface.

PRODUCT SERIAL NUMBER LABEL PLACEMENT

Product serial number labels help identify your system and its factory configuration in the event that your DVR5300 or its components require

service.

Two labels citing your product’s serial number are attached to your DVR5300. One large label is attached to the DVR5300’s rear panel. A smaller

label is attached to the front panel of the unit, behind the bezel.

Because rack mounting and other installation options may obscure the factory-applied labels, a third label is provided for you to attach to your

product documentation or other product location that will not be obscured by installation.

To use this label:

1. Locate the small label on the top panel of your DVR5300, attached with a yellow sticker that reads, “Extra serial number labels: remove

prior to installation.”

2. Remove the yellow sticker.

3. Peel away the backing of the small label and attach it to this installation manual, other product documentation, or an unobscured product

location.

WARNING: Due to the unit’s weight and size, do not unpack the DVR5300 without the help of another person.

HARD DRIVE PACK

SAFETY INSTRUCTIONS

INSTALLATION MANUAL

ACCESSORY PACK

DVR5300

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Pas de commentaire

Pelco DVR5300 Manuel d'utilisateur Page 14