Pelco • 300 W. Pontiac Way, Clovis • CA 93612-5699 USA • Pelco Online @ http://www.pelco.comIn North America and Canada: Tel (800) 289-9100 or FAX (8
10 Pelco Manual C1498M-A (7/99)PAN AND TILT FUNCTIONSUse your controller’s joystick to control pan and tilt operation.• Fixed-Speed Controllers - Pan
Pelco Manual C1498M-A (7/99) 11Software controls scan limit stops. When the dome reaches one, it immediately reversesdirection. Refer to the Limit Sto
12 Pelco Manual C1498M-A (7/99)CM97501. Turn the KEY SWITCH to the ON position.2. Press the PROG key. PROGRAM appears on the LCD screen.3. Press the P
Pelco Manual C1498M-A (7/99) 13Turning off power to the dome does not reset the camera. Camera settings are retained inmemory, and when power is resto
14 Pelco Manual C1498M-A (7/99)2. If the cursor (>) is not beside Camera, move the joystick up or down to position thecursor beside Camera.3. Press
Pelco Manual C1498M-A (7/99) 15SHARPNESSThe two modes for adjusting the picture sharpness are automatic and manual. To changethe mode:1. On the main m
16 Pelco Manual C1498M-A (7/99)• Park – The dome moves to preset 1 when the power-up sequence finishes. The onlytext on the screen is the preset label
Pelco Manual C1498M-A (7/99) 17SCAN LIMIT STOPSRefer to the documentation for your control system for programming presets, then do thefollowing:1. Mak
18 Pelco Manual C1498M-A (7/99)4. Remove the dome drive: Push in on the green drive eject tab on the side of the domedrive and gently rock the dome dr
Pelco Manual C1498M-A (7/99) 19SPECIFICATIONSMECHANICALPan Movement: 360° continuous pan rotationVertical Tilt: Unobstructed +2° to -92°Manual Pan Spe
2 Pelco Manual C1498M-A (7/99)LIST OF ILLUSTRATIONSFigure Page1 System Components (In-Ceiling Model Shown) ...
20 Pelco Manual C1498M-A (7/99)REVISION HISTORYManual # Date CommentsC1498M 2/99 Original version.3/99 Removed reference to line synchronization. Adde
Pelco Manual C1498M-A (7/99) 3IMPORTANT SAFEGUARDS AND WARNINGSObserve the following warnings before installing and using this product.1. Installation
4 Pelco Manual C1498M-A (7/99)2. Set the switches on the bottom of the dome drive. Refer to Table A for the settings forSW1, and Table B and Table C f
Pelco Manual C1498M-A (7/99) 5Receiver Address Switch SettingSW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2-6 SW2-7 SW2-81 ON OFF OFF OFF OFF OFF OFF OFF2 OFF ON O
6 Pelco Manual C1498M-A (7/99)Receiver Address Switch SettingSW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2-6 SW2-7 SW2-857 ON OFF OFF ON ON ON OFF OFF58 OFF ON OF
Pelco Manual C1498M-A (7/99) 7Continued on next page113 ON OFF OFF OFF ON ON ON OFF114 OFF ON OFF OFF ON ON ON OFF115 ON ON OFF OFF ON ON ON OFF116 OF
8 Pelco Manual C1498M-A (7/99)Continued on next page169 ON OFF OFF ON OFF ON OFF ON170 OFF ON OFF ON OFF ON OFF ON171 ON ON OFF ON OFF ON OFF ON172 OF
Pelco Manual C1498M-A (7/99) 9225 ON OFF OFF OFF OFF ON ON ON226 OFF ON OFF OFF OFF ON ON ON227 ON ON OFF OFF OFF ON ON ON228 OFF OFF ON OFF OFF ON ON
Commentaires sur ces manuels