Pelco ICS150 Manuel d'utilisateur télécharger pdf (Page 2)

POS SETUP

The Camclosure Point of Sale (POS) Display can be used as a freestanding exhibit or directly mounted to a wall.

Freestanding Display

1. Install the two support brackets to the back of the display

(refer to Figure 1).

2. Reposition the ICS300 enclosure located on the front of

the display (refer to Figure 2). Loosen the locking collar

at the base of the ICS300 and reposition the enclosure

downward.

3. Pull wiring for power and video.

a. Connect the video cable. (Monitor is not supplied.)

b. Depending on the input voltage, connect either the 12

VDC or 24 VAC input power wires (refer to Figure 1).

ICS300 REPOSITION

DOWNWARD

ICS151-MA6 CONNECT

VIDEO & POWER TO

OPERATE CAMERA.

Wall Mount Display

The mounting surface should be capable of supporting

52 pounds.

1. Prepare mounting surface. Use a minimum of two fasteners

(not supplied) of appropriate size to attach the display to

the wall (refer to Figure 1).

2. Pull wiring for power and video.

a. Connect the video cable. (Monitor is not supplied.)

b. Depending on the input voltage, connect either the 12

VDC or 24 VAC input power wires (refer to Figure 1).

3. Reposition the ICS300 enclosure located on the front of

the display (refer to Figure 2). Loosen the locking collar

at the base of the ICS300 and reposition the enclosure

downward.

Figure 1. Back View

Figure 2. Front View

1 2

Pas de commentaire

Pelco ICS150 Manuel d'utilisateur Page 2